*Please note; Digirig has transitioned to a smaller enclosure size for the Digirig Mobile and DR-891 interface. The DDM-DGRG was designed for the original Digirig Mobile but we now offer an adapter insert to accomodate both the new and older versions using the existing DDM-DGRG. If you've previously purchased a DDM-DGRG for use with the new version and need the adapter insert, it can be found on the Optional Packages and Components page.
Orginal Digirig Mobile Dimensions-
L- 1.675, approx. 1 11/16"
H- .975, approx. 1"
D- .975, approx. 1"
New Digirig Mobile Dimensions-
L- 1.515, approx. 1 1/2"
H- .675, approx. 11/16"
D- .985, approx. 1"
The Armoloq DDM-DGRG is a mounting platform for securing the Digirig to your Armoloq TPA. It’s manufactured from .080 Kydex thermoplastic in a sleeve style design. Retention is obtained through compression, in addition to hard stops at the top and bottom, preventing the Digirig from shifting up or down when plugging in or removing connections.
* You will not need the Data Relocation Package if you're running the DigiRig affixed to your TPA. The suggested installation is to utilize the appropriate cabling offered from DigiRig for your radio and dress the excess cable into the open area at the rear of the TPA.
Installation-
-
Secure the DDM-DGRG to the TPA.
-
Slightly open the upper section of the DDM-DGRG.
-
Place the Digirig in the top and begin pressing the unit downward into the mount, until it passes the top stops and snaps into position.
Removal-
-
Disconnect all connections.
-
Slightly open the upper section of the DDM-DGRG and push the Digirig past the top stops.
The DDM-DGRG can accommodate right angle USB-C connections but the Digirig must be rotated 90 degrees clockwise or counterclockwise, as shown in the photos labeled “Right Angle”.
Specs-
L- 2.750
W- 1.125
D- 1.250
Wt. w/o Digirig- .5 oz
Wt. w/ Digirig- 1.5 oz
Colors available- Matte Black
Hardware included- 2 socket head screws and 2 nuts.
Optional-
Armoloq DDM-DGRG/AI- Digirig Mobile mount adapter insert
Designed to provide a secure seating for the new, smaller Digirig Mobile and Digirig DR-891. The insert allows the current DDM-DGRG to be cross compatible between the new Digirig Mobile and the older Digirig Mobile. Please refer to the photos in the gallery if you're unsure which Digirig Mobile you're using.
Package includes-
DDM-DGRG adapter insert- 1
Hardware- M4 x 16mm, button head screw- 2
Colors available- Matte Black
Weight- .60 oz
Length- 1.680
Width- .910
Heigth- .530
*This is an FDM (3D printed) component that went through several iterations before finalizing. Produced with PETG.
